Do you know what inspection should be done after the main part of the universal milling machine is installed?

Universal milling machine is a combination of milling machine parts. All parts need perfect integration and cooperation to realize all functions of #UniversalMillingMachine. Therefore, when the main body of the universal milling machine is installed, the work is not finished and a series of inspection is needed. Today we're going to talk about what else needs to be done.

After the main body of the universal milling machine is installed, the cable, the oil pipe and the gas pipe need to be connected first. All the cables and pipes to be connected shall be properly connected according to the requirements of the electrical wiring diagram and the gas pressure line diagram in the milling machine instruction manual. The connection shall be clean, decontamination and reliable plugging and sealing. When the cable is installed, the fastening screw must be screwed down to ensure the contact of the joint plug is completely reliable. When connecting oil and gas pipes, foreign bodies should be prevented from entering the pipeline, resulting in failure of the whole hydraulic system. Each joint must be tightened, otherwise it will leak in the test and increase the amount of rework.

In addition, it is necessary to check whether the plug-in units in the universal milling machine have any looseness or damage due to long distance transportation, and check whether the components are in good contact with each other. For some imported universal milling machine, often because the work voltage standards are not the same, the need for another transformer. Before switching on, check the voltage and frequency of the input power carefully.

Finally, we should check the connection status of all parts of the milling machine, and check if there is excess thread and pipe joints. Only through careful and careful work, can the universal milling machine be operated smoothly.

For more information, welcome to visit the website：http://www.cndxmc.com/2017/06/29/do-you-know-what-inspection-should-be-done-after-the-main-part-of-the-universal-milling-machine-is-installed/